 |
|
|
 | Service lights at night help with maintenance |
The service lights package gives excellent lighting on both sides of the combine body as well as the engine compartment.
When the service lights are turned to the on position, there will be a slight delay because the circuit is run through a controller. The controller is trying to prevent the lights from being left on too long, which lowers the battery voltage to a point where the machine will not start.
| | |
NOTE: When the service lights have been on for more than 10 minutes, the lights will flash. The lights will go to the off position for 1 second and back to the on position for 20 seconds. This will continue for 3 minutes before totally shutting off. When the lights turn off, a person can turn the the switch off and then on again, and the lights will remain on for an additional 10 minutes. A warning flash after 10 minutes will continue to flash the lights for 3 minutes, and then go off again. The system allows the lights to come on for another 10 minutes, unless the system voltage is so low the lights will not come back on until the machine is started and the battery voltage system is recharged.
Base Equipment On : 70 Series Combines
| | |
| Field-installation information |
| |
The service lights attachment also requires a 200-amp alternator up to serial number 715301.
| | | | |
| Code | Attachment | Description |
| | BH84501 | Service lights, 200-amp alternator in base equipment on 60 and 70 Series Combines
NOTE: For all 50, 60, and 70 Series STS™ Combines. |
|
| | | Last Updated : 06-Jan-2022 | | | | |
| | |
